10 Helpful PCB Assembly Tips for Product Developers

01-11 | Industry

Where do you start to ensure that your idea becomes one of those great products that people will appreciate and love? Start by looking for professional electronics contract manufacturer and get familiar with these helpful tips.


Which layer of information do we need to know about PCB?

01-11 | Industry

Here is the layers which we need to know for PCB fabrication. 1.Top layer, 2.Bottom layer, 3.Top/bottom solder layer, 4.Top/bottom paste layer, 5.Top/bottom overlay layer, 6.Mechanical layer, 7.Keepout layer,


What information is must required for PCB fabrication?

01-11 | Industry

PCB fabrication, assembly, and test require a set of industry-specific information in the form of schematic drawings, stack-up drawings, BOM, etc. Manufacturers also customize these deliverables as per their capabilities and customer requirements.


How many kinds of surface finish of the PCB we usually met?

01-11 | Industry

In circuit board manufacturing, the process of implementing the PCB surface finish is critical in enhancing the reliability and shelf life of the PCBA. We will cover the various types of surface finishes the printed circuit boards are given to enhance


The unique advantages of PCB - China PCBA Supplier

01-11 | Industry

Can be high density: The high density of printed boards can grow with the integration of integrated circuits and advances in mounting technology. High reliability: Through a series of inspections, tests and aging tests, the PCB can be reliably


Inner layer inspection process - China PCBA Supplier

01-11 | Industry

The image is fed back to the device processing by the optical reaction principle, and compared with the logic judgment principle or the data pattern of the design, the defect position is found.


Lamination process---browning introduction - China PCBA Supplier

01-11 | Industry

Browning purpose: (1) roughening the copper surface to increase the surface area in contact with the resin; (2) Increasing the wettability of copper against flowing resin; (3) Passivation of the copper surface to avoid adverse reactions


Classification of SMT production lines - China PCBA Supplier

01-11 | Industry

SMT assembly equipment can be divided into 7 categories, and different categories are for different production steps. The following is a classification of SMT production lines: According to the board welding process: there are wave soldering equipment


PCBA Conformal Coating - Leading PCB Assembly Manufacturer

01-10 | Industry

In fact, the "Conformal Coating" also have anti-vibration, anti-friction, improve the insulation strength, prevent the failure of the printed circuit assembly board (PCBA), guarantee and extend the service life of the product. Coating technology is


Improper design causes the failure of chip capacitors and solutions

01-10 | Industry

PCBA is prone to buckling when some sub-boards are assembled. If there is a chip capacitor around the daughter board connector, cracking is likely to occur.


How to avoid the case where the pad does not match the component pin size

01-10 | Industry

How to avoid the case where the pad does not match the component pin size. For the arc-shaped surface end welding surface, the pad must be in contact with the welding end due to the influence of the arc.


Attention for BGA Layout Design during PCBA processing

01-10 | Industry

BGA has a large pad package but the solder jointa is small. BGA layout design requirements 1.Place the PCB near the transfer side as close as possible. Because the deformation is relatively small during soldering.


blog-product

GET 20 OFF FOR
FIRST ORDER

Contact Us

GET 30% OFF

On Your First PCB Assembly Order!